pic: ball laucher [Archive]

View Full Version : pic: ball laucher

Kyle A

06-02-2006, 22:01

[cdm-description=photo]22780[/cdm-description]

Goldeye

06-02-2006, 22:01

Don't these small wheel demolish the ball?

Bemis

06-02-2006, 22:36

They are six inches, I believe, same as our drive wheels, so not that small. We had no trouble with the wheels demolishing balls though. There isnt a whole lot of compression on them.

Arkorobotics

07-02-2006, 17:35

Hey, what part did you use to connect those wheels to the shaft of the CIM motor?

Cody Carey

07-02-2006, 17:57

http://www.chiefdelphi.com/forums/showthread.php?p=447619#post447619

There is a drawing here... and they are soft rubber, so there is NO problem tearing up the balls :)

Arkorobotics

07-02-2006, 20:41

http://www.chiefdelphi.com/forums/showthread.php?p=447619#post447619

There is a drawing here... and they are soft rubber, so there is NO problem tearing up the balls :)

go to McMaster and type in 2469k2, would that work? or would i rip up in place? :confused:

Cody Carey

07-02-2006, 22:40

I would use the keyed one, or add a setscrew for each shaft, but yeah... That would probably work quite well :)