Log in

View Full Version : Oh no... a broken antenna...


Japper
25-01-2007, 08:54
Ok, someone broke the RC antenna on our chassis and it wasn't me...

Anyhow, does anyone know where I might find a replacement antenna or will
we have to buy a new RC remote unit?

Also, didn't see anything in the rule book but would a replacement antenna on this unit be dis-allowed?

Please advixe

Thanks

kaszeta
25-01-2007, 09:11
We broke ours as well. For now, we've got an antenna from an old OI radio in it's place.

Dad1279
25-01-2007, 09:17
IFI sells them.

billbo911
25-01-2007, 10:35
IFI sells them.

Ditto

synth3tk
26-01-2007, 23:53
Or, try coat hangars. No rule against that! :D

Viper37
27-01-2007, 01:43
Try soldering it around the ends, then putting tape around it to reinforce it.

If that doesnt work for you, get an antenna off something similar or use a good old fashion coat hanger. :)

mtaman02
27-01-2007, 07:07
IFI sells them at www.ifirobotics.com for about $8 w/o tax HOWEVER I would not suggest taking apart the unit since it is under warranty and any more accidental damage to it may void the warranty, So you can use a Coat Hanger, Purchase the Antenna from IFI or contact IFI and see what they can do so that the warranty stays intact.

waldo3
27-01-2007, 14:19
the antenna is basically just slipped over a brass joint. depending where its broken, and i assume its very near the joint, just remove the broken piece either on a lathe or by dremel and slip the remaining piece over it and centre punch it back on. thats what we did

Robo_Coyote
27-01-2007, 14:34
use sand paper to get the top layer of chrome or whatever it is to get done to the brass then solder is back together worked very good for us.