TimK
20-07-2007, 23:09
Hi,
I purchased the CMUcam2+ in order to have the camera integrated in to a robot. When I power the camera using a 8.5 DC adapter, 350mA, the Power LED turns green and the SX52 processor on the camera's PCB gets so hot that you can't touch it(about 50 + degrees C)! My question is; is this normal?( I am assuming not) How can I fix this? I tried a 6 V power supply made of 1.5 V alcaline batteries and the SX52 still heats up!
1.I tied to set up communication with a PC by building a RS232 Level Converter with no luck.
2. Tilt/PAn auto mode does not work as outlined in the CMUcam2 manual.
3. None of the status LED's light up
I purchased the CMUcam2+ in order to have the camera integrated in to a robot. When I power the camera using a 8.5 DC adapter, 350mA, the Power LED turns green and the SX52 processor on the camera's PCB gets so hot that you can't touch it(about 50 + degrees C)! My question is; is this normal?( I am assuming not) How can I fix this? I tried a 6 V power supply made of 1.5 V alcaline batteries and the SX52 still heats up!
1.I tied to set up communication with a PC by building a RS232 Level Converter with no luck.
2. Tilt/PAn auto mode does not work as outlined in the CMUcam2 manual.
3. None of the status LED's light up