pic: Dawgma 1712, Done.

[Chuck Glick]

[cdm-description=photo]29580[/cdm-description]

[Seraph117]

if this is seriously your final design, ill eat my hat

[Chuck Glick]

if this is seriously your final design, ill eat my hat

depends on the kind of hat that will be eaten, then I will decide. :p

[Seraph117]

see my signature? :cool:

THAT KIND

[Woody1458]

so the drill motor powers the wheel at top sucking in the ball?, does it hold it stiffly enough? can pop out if hit side ways?

[lukevanoort]

I spy a spider leg...

[Seraph117]

o_O

UM...

i think those are zip ties...

[Chuck Glick]

so the drill motor powers the wheel at top sucking in the ball?, does it hold it stiffly enough? can pop out if hit side ways?

Remember this is just a prototype. That whole mechanism was designed and fabricated to see if it would work, however the final will be a bit wider that the 1.5" that were contacting the ball during testing.

Also, we used a DRILL, not just the motor, its one of our common testing practices to just use the drill to power the shaft.


I spy a spider leg...

Well lets just say that our rack became the robot. :rolleyes: It had a nice flat face and was already the right length so, why not?!