pic: Team 1631 teaser...what happened?

[calvin1631]

[cdm-description=photo]29693[/cdm-description]

[sdcantrell56]

Im gonna go ahead and take a good guess that your gripper is some form of suction device.

[Xenozero]

did you guys try to squeeze it in a tight position, through a door perhaps, ?

[calvin1631]

We don not have our gripper fully operational yet and we did not squeeze it. It was something we made using the ball that caused it to balloon. We thought the ball might reform but it is still bulbous from making a _________ form. What fills in the blank? Anyone?

[Akash Rastogi]

were you making fiberglass molds perhaps? we were considering doing something like that in the beginning.

[calvin1631]

and the jackpot is gone!

[Akash Rastogi]

and the jackpot is gone!

anyone right?

[daftpunk79]

im guessing heat....

[vivek16]

yeah, Im going to go ahead and guess vaccuum.

Either that or some freshman tried to use the ball as a table for soldering. lol

-vivek

[DonRotolo]

Good way to pop the ball, by using it without the cover.

[calvin1631]

We fiberglassed the ball, just that section. It caused the ball to deform in a strange way. :ahh:

[Akash Rastogi]

We fiberglassed the ball, just that section. It caused the ball to deform in a strange way. :ahh:

:D yay..i was right for once.
Like i said, it was a possible design during the first day or so after kickoff. but then we were like...no. lol

[calvin1631]

We fiberglassed the ball, just that section. It caused the ball to deform in a strange way. :ahh:

[Wayne C.]

it is preparing to hatch?

[calvin1631]

Yes, our robot was completely constructed inside the ball and takes 3 weeks to hatch...which mean since we got it about 2 weeks ago we have 1 week left to wait.