Log in

View Full Version : Wiring analog breakout?

excel2474
31-12-2008, 15:46
I'm not quite sure how to power the analog breakout. Thanks for the help.
Jason Law
31-12-2008, 16:40
I'm not quite sure how to power the analog breakout. Thanks for the help.

You can read Chapter 3 (pg. 20 - 26) of the 2009 Control System documentation on FIRST's website (found here (http://www.usfirst.org/community/frc/content.aspx?id=10934))

More specifically, you can find out how to pass power to the analog breakout on page 24 of Chapter 3 (http://www.usfirst.org/uploadedFiles/3-FRC%20Control%20System-Component-Datasheets-Rev-0-5a.pdf).

Hope this helps,

Jason Law
excel2474
31-12-2008, 16:41
Ok thanks I'll check that out.
excel2474
31-12-2008, 17:14
Where does the analog breakout get plugged into the distribution block.
Jason Law
31-12-2008, 17:20
Where does the analog breakout get plugged into the distribution block.

If you look at the power distribution diagram (found here (http://www.usfirst.org/uploadedFiles/3-FRC%20Control%20System-Component-Datasheets-Rev-0-5a.pdf)), you will find that the analog breakout is connected to the 30A connectors on the power distribution board.

Hope this helped,

Jason Law
excel2474
31-12-2008, 17:30
Ok, thanks for the help.