Problems "Seeing" the Wireless Bridge

[Chipawa]

So our laptop can communicate with the wireless router - both directly and when conected to the Drivers Station - but we can't see the wireless bridge. We've set the IP address to 10.11.11.1 (Team 1111), but it's not showing up on our local network.

Any suggestions would be appreciated.

-Chip Tucker

[Mark McLeod]

Check the security settings of both the bridge and the router.
It's easiest to turn them both off.

[usbcd36]

The bridge gave us a lot of trouble. It's best to reset to default settings, then connect a computer to it and use that computer to configure it to work with the router.

Also, be sure you've set the router to start DHCP addresses at 10.11.11.10.

[JeffChan]

Check the security settings of both the bridge and the router.
It's easiest to turn them both off.

We ran into the same issue and that solved it.

[Chipawa]

Thanks all. We read back over the documentation, followed the instructions step-by-step and now have it working. Sometimes you just have to read the directions.

Now we can move forward and encounter new problems!

-Chip Tucker