Log in

View Full Version : Programming Camera that uses USB

Comatose
10-02-2009, 22:15
Is there a way to set the camera by USB if you use a different camera? If so, how?

Thanks,

Comatose
Daniel_LaFleur
10-02-2009, 22:17
Is there a way to set the camera by USB if you use a different camera? If so, how?

Thanks,

Comatose

There is no USB on the cRIO
Comatose
11-02-2009, 20:28
There are converters from USB to Ethernet, so it would be a problem for programming. Can you set up a USB one if it was connected through a converter?

Thanks,

Comatose
Joe Ross
11-02-2009, 20:34
There are converters from USB to Ethernet, so it would be a problem for programming. Can you set up a USB one if it was connected through a converter?

See <R67>
Stuart
11-02-2009, 21:19
If you were to have an off board computer,that did not violate any COTS rules, and you hooked said computer to the cRio using the serial port or some other port. then yes you could have a USB camera . .you would also have to program every thing to get the camera to work with the off board computer, how it would communicate, then what it would do after that. So yes it is possible.
RyanCahoon
12-02-2009, 01:14
If you were to have an off board computer,that did not violate any COTS rules, and you hooked said computer to the cRio using the serial port or some other port. then yes you could have a USB camera . .you would also have to program every thing to get the camera to work with the off board computer, how it would communicate, then what it would do after that. So yes it is possible.

This is the way you'd have to do it, but you're out of luck for the serial port. Digital I/O, Analog In, I2C only.