Coupler for 8mm CMI motor

[sbrumund]

Does anyone make a coupler that will go from the 8mm shaft of the CMI motor to a standard 0.50 shaft with keyways?

We want to drive our ball thrower directly off of the CMI motor but cannot find a coupler to go from the 8mm motor shaft to the 0.50 wheel hub.

[MrForbes]

did you look at the replies to your previous thread?

http://www.chiefdelphi.com/forums/showthread.php?t=74058

also it would help if you told us if you want to connect to a 1/2" shaft, or you want to make the motor shaft into a 1/2" shaft so you can put something with a 1/2" hole over it

[SpaceOsc]

http://andymark.biz/am-0320.html

if u want to drive another shaft directly combine that with any other of these hubs http://andymark.biz/hubs.html