Code downloaded but not working... :(

[pudgeball]

Alright so our team, team 2386 got all the updates for the software and driver station. Today I updated the cRio to v19 and we finally got the programming laptop able to download code. Then when we went to test the code nothing happened. There was a green light for Robot Code, but I was unable to use the robot. Anyone have any ideas?

[Alan Anderson]

Did you click the "Enable" button on the Driver Station to enable the robot?

[pudgeball]

Haha yea I tried all the modes and enabled them all. No luck on all fronts.

[Alan Anderson]

Haha yea I tried all the modes and enabled them all. No luck on all fronts.

I don't understand what you mean by "all the modes". There's a red and green button on the operations tab to enable or disable the robot. That's the one I'm talking about.

Can you describe what the Robot Status Light is doing when you try to run your program?

[pudgeball]

Sorry about this thread, I found the error while re-reading the documentation. The electrical was screwed up. We got the robot working.