Can not connect to cRIO

[z.s.tar.gz]

We are trying to run the sample robot code, but we keep getting this:
Error connecting to 'VxWorks6x_10.32.42.2' (Registry localhost). Failed to launch target server
Possible casused by: back-end not connected

Remove dead entry from registry!

What could be causing this?

[Chasegd128]

We had the same problem. We re-imaged the cRIO and it then decided to work. So your best bet would be to re-image it. Good luck!

[byteit101]

are you physically connected to the robot?
good battery?
correct network settings?
there are probably more reasons this could come up, but those are the three most common