Banebots P80

[Spirator]

Hey everyone,

We're trying to mount our CIM onto one of the P80's, specifically the P80K-43-0005 which is the 27:1 model. Where do we put the screws and are there any other ways to mount the motor? ;)

Thanks.

[O'Sancheski]

to use the banebots with CIMs you need to completely take the tranny apart... then as it says on the sticker, you must grease all of the gears... then you mount the motor to the back plate with two screws ant assemble it and your good to go...

hope this helps