how do i get a pressure gauge on my driver station instead of the gyro gauge [Archive]

2544HCRC

20-02-2010, 18:52

Hello Everyone,

Our team has been wondering if there is any way to i get a pressure gauge on the driver station instead of the gyro gauge. If anyone has any info let us know

Joe Ross

20-02-2010, 19:46

You would need an analog pressure sensor if you want anything other then the binary value that the provided pressure switch provides.

eovnu87435ds

20-02-2010, 23:59

or, if you have a pan/tilt camera on your robot, have a joystick button set the servo values to make it look at the camera, and press it again to reset. you could also place the gauge on a conveyor belt, or a thin piston, to have the gauge temporarily moved infront of the camera.

No one said it had to be high tech...

EricWilliams

23-02-2010, 11:08

or, if you have a pan/tilt camera on your robot, have a joystick button set the servo values to make it look at the camera, and press it again to reset. you could also place the gauge on a conveyor belt, or a thin piston, to have the gauge temporarily moved infront of the camera.

No one said it had to be high tech...

If this post wasn't so long, I'd spotlight it.