Default NI robot control program?

[jgruber2713]

Hello, I understand there is default NI robot code provided within the KOP or NI software. i.e a basic driving / control program. I’m new to LabView programming. Can someone give me information on where to find it? :confused:

[Mark McLeod]

After the LabVIEW update (http://usfirst.org/roboticsprograms/frc/content.aspx?id=18758) has been installed you will see it as a choice on the LabVIEW startup window.

It's highlighted in this picture (http://www.chiefdelphi.com/forums/attachment.php?attachmentid=9670&d=1294952656).

[jgruber2713]

Thanks Mark! I appreciate the info. Will pull down the update and install.

Best Regards,
Joe