E-stop bypass?

[2bkrul]

Is there a way we can bypass the e-stop button using LabVIEW so we can run our robot. We have to order a new button and we would like to run code while we are waiting for the replacement

[captainking]

go to the "diagnostic tab" iirc, double click on the "stop button" part

[Bonzo]

when you double click it, the question of whether you you will be careful or not pops up. just click yes and you will wait about 20-30 seconds for an over ride to occur then go ahead and enable and have fun!

[andreboos]

What problems are you having with your old one?

Our old button only registers when we have the wire at a certain angle, give or take a few degrees, so we ordered another last week. Is this a problem that other teams are having too?

[JohnBoucher]

What problems are you having with your old one?

Our old button only registers when we have the wire at a certain angle, give or take a few degrees, so we ordered another last week. Is this a problem that other teams are having too?

Same issue. Something is loose.

[Bryscus]

I think the button just has a couple of screws and may be snapped together as well. You can probably open it up and re-solder the wires. It should be a simple fix - there are only 4 wires for USB 1.1/2.0.

- Bryce

[Jon Stratis]

Our stop button was having a similar problem... turns out there was a loose wire in the USB header that plugged into the computer. Snipped the cord, soldered on a new one, and we were good to go.

[2bkrul]

Same issue. Something is loose.


Same here. The cord is loose by the USB