Need BanBots P80 12:1 Mounting Dimensions

[cpriese]

The data sheet on this gearbox is unclear. Can one tell me the correct mounting bolt hole pattern? Need the locations for the holes that go into the sides - not the holes with axis parallel to the gearbox shaft.
Thanks!

[MattC9]

If you have CAD you can go and print out your OWN! templates, PM me if you have any questions

[cpriese]

The data sheets on Banebots website are not legible and appear to be wrong. Cannot find any CAD on the internet that seems reliable. I have CAD and have made my own model to the data sheets but the mounting info is not apparent. Do you have a P80 12:1 gearbox? Looking for someone with one so the dimensions can be measured directly.

http://banebots.com/docs/P80A-DATASHEET.pdf
see page 26

[Teched3]

Looking at the banebot drawing on page 26, I come up up with the following for the 1/4-20 mounting holes:

Dimension parallel to the shaft axis, center to center: 2.263"

Dimension perpendicular to the shaft axis, center to center: 1.378", centered on the shaft axis. (0.689 off center axis.

These dimensions are from the "incomplete" banebot CAD drawing. We have used them in the past, but I won't physically have in hand until tonight.

PM me if these are not the dimensions you are after. Hope this helps.:) :)
Anyone else out there that wants to chime in to verify or change, please do!

[cpriese]

Can you veirfy the dimensions when you recieve your gearbox and post back? I'd hate to start making holes to wrong data.
Thanks!

[Teched3]

A snowstorm has locked down the school. I have an EMail out to another mentor on our team to verify the dimensions.:( :(

[cpriese]

Thanks for checking. BaneBots called me back yesterday. They confirmed the dimensions you said 1.378 x 2.263.

Now the only problem is I cannot get my gearbox order till next week - best case! :ahh: If you have 4 of these gearboxes laying around - I'll take'm!