Driver Station Velcro

[delsaner]

Hello everyone,

Myself and another member of our team are designing a new control board for the robot, and from our knowledge and understanding, there is velcro on top of the driver station platforms (the ones for drivers to put their control boards on). Would anyone have any idea where specifically they are located? I am looking for spacing from each other and any other dimensions that are significant. I checked the field drawings and I could not find anything.

Thank you very much! =]

[anyheck]

From my memory they placed a strip or two long ways down the drivers station. I think the 2" size.

When we put some on our control board I didn't know if it was the hook or loop so I just put two strips of each short ways across the bottom of the board.
The drivers never had a problem with that arrangement.

[Mark McLeod]

It's in the manual Arena section 2.2.8.

...The support shelf measures approximately 60 inches wide by 12 inches deep. There is a 4-1/2-foot long by two-inch wide strip of Velcro tape (“loop” side) along the center of the support shelf that may be used to secure the OPERATOR CONSOLES to controls the ROBOT...