Chief Delphi - Classmate says theres 0.0 volts

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- NI LabVIEW (http://www.chiefdelphi.com/forums/forumdisplay.php?f=182)

- - Classmate says theres 0.0 volts (http://www.chiefdelphi.com/forums/showthread.php?t=100829)

Mr.Trips

21-01-2012 17:03

Classmate says theres 0.0 volts

Hello. We are having trouble in our driver station window. The voltage reads zero when I know it should have 12.27 or something. Please help us Thank you:yikes:

RufflesRidge

21-01-2012 17:06

Re: Classmate says theres 0.0 volts

Make sure you have an Analog Module in slot 1 of your cRIO, with an Analog breakout mounted on it. The Analog Breakout must be powered and the jumper must be installed on the outside two pins of the Battery Selection header. See this doc for a picture of how the jumper should be installed:
http://www.usfirst.org/sites/default...20Breakout.pdf

Tom Line

21-01-2012 17:07

Re: Classmate says theres 0.0 volts

You need to install the jumper on the analog module in your cRio. Look through the control instructions.

Mr.Trips

21-01-2012 17:11

Re: Classmate says theres 0.0 volts

Thank you!!!

DominickC

21-01-2012 20:14

Re: Classmate says theres 0.0 volts

Quote:

Originally Posted by Tom Line (Post 1110671)

You need to install the jumper on the analog module in your cRio. Look through the control instructions.

Where might I find these instructions?

plnyyanks

21-01-2012 20:26

Re: Classmate says theres 0.0 volts

Quote:

Originally Posted by DominickC (Post 1110794)

Where might I find these instructions?

Getting Started With the 2012 Control System (page 12)

DominickC

21-01-2012 20:30

Re: Classmate says theres 0.0 volts

Ah, thanks!

All times are GMT -5. The time now is 11:34.