digital input
 

We have an external DI switchboard that we want to know how to code. When we open driverstation, it comes up under the i/o with DIs, so we know the computer sees it, but we don't know how we would be able to use them in the code. We tried opening a DIO in begin, but that is only for i/o's on the digital sidecar.

Re: digital input
 

By default the digital IO you get from the Cypress board connected to the Driver Station is in "Compatibility Mode".



The vi's to get the data inside your code can be found in the programming palette:

WPI Library -> Driver Station -> Compatibility IO

The vi's you'll use most are:

• Get Digital In
• Get Analog In

There is an extended set also available called "Enhanced Mode"

Re: digital input
 

Under the Driver's Station Palette, there is an Get Digital IO.

WPI Robotics Library/Driver's Station/Compatibility IO/Get Digital Input

Re: digital input
 

:D Thanks

Re: digital input
 

ok we ran into another problem. We know how to read it, but then how would we read only one of them, and then see if it is true?:ahh:

Re: digital input
 

nevermind we got it.