High-Low gearbox?
 

Hi,

All the gearboxes I've seen on Andymark seem to be reduction gearboxes (geared for torque, small to big).

I'm looking for a gearbox that is geared for speed (big to small), or even better, allows you to use any gear ratio.

Do you guys know of some?

Thanks,
3992

Re: High-Low gearbox?
 

I take it your looking to speed up a motor?

I'd recommend looking at AM's website for gears or other sites and cutting your own plates. Are you looking to prototype?

The Modulox looks pretty cool for prototyping - http://www.modulox.com/

Or do you know your final ratio and just want to design a gearbox?

-RC

Re: High-Low gearbox?
 

Well essentially we'd just like a gearbox where we can choose the gear ratio.

Does modulox accomplish that?

And if so is there anything cheaper?

Re: High-Low gearbox?
 

I guess the better question would be:

-What are you attempting to do?

-Are you prototyping?

-RC

Re: High-Low gearbox?
 

If it's a muti-stage gearbox you could straight up switch the big and small years, thus inverting that part of the reduction.

Re: High-Low gearbox?
 

If you have the room and weight allowance to spare, chain and sprockets would work well for this. Attach a larger sprocket to the motor and a smaller sprocket to the driven axis. Just make sure the motor can handle the torque increase applied to it.

Re: High-Low gearbox?
 

We're trying to gear a motor for speed, but would like the ability to gear it for torque if we see fit with the same item purchased

Re: High-Low gearbox?
 

If you take the example I used, just swap the sprockets.

Re: High-Low gearbox?
 

That still doesn't have as much as an effect as a motor geared for speed though.
The motor would still be geared to be slower, which really isn't what we want.

Yes, what you said will make it faster; but not to the degree we want to reach.

Re: High-Low gearbox?
 

What speeds are we talking about? All of the kit motors that don't already have a gearbox on them have a free speed of 10,000+ rpm (with the exception of the CIM at ~5000). Are you sure you need more than 5000 rpm? And I'm assuming this is not your drive and you're using 4 CIMs in your drive, so in that case, more than 10000rpm?

Re: High-Low gearbox?
 

Actually we are indeed testing with CIM's.
We want to gear them for speed to prototype a launching mechanism.

Re: High-Low gearbox?
 

If you want something like 2:1, I would go with the sprocket and chain suggestion, although you may not have sprocket with a 5/16" / 8mm bore lying around. We used a 10:42 chain reduction with #25 chain of off CIMs (and then CIMple boxes and RS775s) in our tests with 8" wheels, and the speeds were plenty for any half court shot or closer. With 4" wheels you would want something like 16:32 (all these sprocket sizes are available from Andymark, although it's better not to wait for things to ship unless they're going on the final product) to get comparable speeds. Alternatively, you could find some timing belt pulleys in that range and find some quick and dirty way to fasten the large wheel to the shooter wheel, or whatever it is you're turning. I realize you may not be testing a shooter wheel, but for most of these mechanisms the speeds required are in the same ballpark. You shouldn't need to gear the CIM up. If you absolutely must, try swapping sprockets/pulleys as already mentioned.