Red Light Crisis on Spike
 

Hi
We are using pneumatics on the robot and we have all the components ready. Compressor piston solenoid air tanks and spikes. When we hit the button on the joystick in order to start the piston the spike connected to the piston flashes red. But I know that it should be green. What can be done to solve it ? Any ideas ?

Re: Red Light Crisis on Spike
 

I believe the light color depends on the direction of the output voltage. Does the compressor turn on?

Re: Red Light Crisis on Spike
 

[quote=cilginbilgin;1115893start the piston the spike[/QUOTE]


The way you phrase that, it makes it seem that your have the pneumatics cylinder is wired into the spike?

Re: Red Light Crisis on Spike
 

We have a solenoid valve that is wired to the spike.

Re: Red Light Crisis on Spike
 

Ok well there's your problem. The solenoid valve needs to be plugged into the solenoid break out on the crio.

and I highlighted cylinder because calling it a piston is a pet peeve of mine. lol

Re: Red Light Crisis on Spike
 

Oh and depending on what kind of valve it is 12v or 24v. it needs the proper wiring.

Re: Red Light Crisis on Spike
 

You can drive a 12 V solenoid valve with a Spike relay. You can even put multiple solenoid valves on one relay:

Is the light flashing or solid? A solid red light means the relay is set to reverse. To set it forward (green light) you need to change the direction of the relay in your code. What language are you using?

EDIT - Seems the OP is trying to use a 24 V solenoid. In that case, you have to use the solenoid breakout. And you do not connect a Spike to the solenoid breakout; you connect the solenoid valve directly to the solenoid breakout. If you want to use a Spike to drive a 12 V solenoid valve, you connect the Spike to the digital sidecar, never to the solenoid breakout.

Re: Red Light Crisis on Spike
 

I will start from the very beginning.I have a solenoid valve that is wired into the spike.

Here is the valve that we use.

http://www.festo.com/rep/en-us_us/as...ions_2011b.pdf

Then I wired the pwm output of the spike to 2 ports on the solenoid breakout.

Re: Red Light Crisis on Spike
 

Well I didn't know that thanks. I just find it easier to use the break out. It saves space.

Re: Red Light Crisis on Spike
 

Well thats a 24v and it has to go to break out and that pictures seems to be wired wrong.

Re: Red Light Crisis on Spike
 

But there are lights on both corners of the valve.

Doesn't this mean that valve is powered correctly ?

Re: Red Light Crisis on Spike
 

Here is our code.

Re: Red Light Crisis on Spike
 

Not quite, On one side of the valve power and ground need to come from the PD and the other side goes to the ground and power side of the spike (M+, M-).

But if it is a 24v valve, it needs to be wired to a 24v breakout. It will only get 12v for a spike.

Re: Red Light Crisis on Spike
 

cil,
When you use a 24 volts solendoid valve, the only legal and correct way to use it is to wire the solenoid module in the Crio for 24 volts. There is a wiring diagram on the First website to assist you. I believe you can find it in the KOP section. The Spike can only control 12 volts. While some people have reported that their 24 volt valves work on 12 volts, they are not reliable at that voltage.

Re: Red Light Crisis on Spike
 

So what you are saying is don't wire the spike with the valve , just wire the valve to the solenoid breakout ? OR...