Chief Delphi - Anyone work at Pratt Whitney in Engineering?

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Chit-Chat (http://www.chiefdelphi.com/forums/forumdisplay.php?f=14)

- - Anyone work at Pratt Whitney in Engineering? (http://www.chiefdelphi.com/forums/showthread.php?t=101515)

sanddrag

30-01-2012 00:01

Anyone work at Pratt Whitney in Engineering?

I have a rather specific question regarding a rather specific part, and I'm wondering if anyone on here by chance works in engineering (preferably mechanical) at Pratt Whitney. If so, send me a PM. Thanks.

Ether

30-01-2012 00:12

Re: Anyone work at Pratt Whitney in Engineering?

Quote:

Originally Posted by sanddrag (Post 1116276)

I have a rather specific question regarding a rather specific part, and I'm wondering if anyone on here by chance works in engineering (preferably mechanical) at Pratt Whitney.

I worked at P&W's West Palm Beach gas turbine engine test facility back in '82. I had a condo overlooking the PGA National Golf Course.

sanddrag

30-01-2012 00:15

Re: Anyone work at Pratt Whitney in Engineering?

Well, I may as well post here. I have a print for a part with splines and it references a PWA 350 Class 6 spec. I speculate it's from the 1970s or possibly 1960s. How would I go about finding out what is in this specification. From the measurements on the print, it clearly is not an ANSI spline.

Ether

30-01-2012 00:20

Re: Anyone work at Pratt Whitney in Engineering?

Quote:

Originally Posted by sanddrag (Post 1116286)

Well, I may as well post here. I have a print for a part with splines and it references a PWA 350 Class 6 spec. I speculate it's from the 1970s...

Sorry. In the '70s I was at the General Electric Riverworks jet engine plant in Boston.

All times are GMT -5. The time now is 03:54.