Chief Delphi - Alternate Source for 1/2" Flanged Hex Bearings

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- General Forum (http://www.chiefdelphi.com/forums/forumdisplay.php?f=16)

- - Alternate Source for 1/2" Flanged Hex Bearings (http://www.chiefdelphi.com/forums/showthread.php?t=102088)

Re: Alternate Source for 1/2" Flanged Hex Bearings

Is there some reason VexPro was not mentioned? We just got a bunch of flanged hex bearings from there.

Re: Alternate Source for 1/2" Flanged Hex Bearings

Quote:

Originally Posted by Andrew Remmers (Post 1120983)

Its pretty hard to get those bearings, I have a lot of contacts and they could only find the Andymark bearings. However I did find a .5 inch Flanged Hex bearing with a 1.25 OD I think, those didn't quite work with our design so we went with the Andymark ones.

I did some searching and I found the bearing

http://www.wholesalebearing.com/ufhexbore.html

Hope this helps. Clearly it was 1.5 OD So its a bigger bearing but it might work

- Andrew

We tried Lutco yesterday and they do not have any in stock or really wanted to deal with us (there right down the street) but the OD may make things a bit more complex in terms of space. I believe the vex pro bearings had a recall or something like that i called them yesterday and they claimed that they may have some in next week but they will make no guarantee. I also called andymark and they said that they had an order in then they were sent out locally for a modification and are trickling back, they should be back in stock by next week

Re: Alternate Source for 1/2" Flanged Hex Bearings

Does anybody know where to get 1/2'' hex bearings that have an outside diameter larger than 1.25? We messed up a part and would like to fix the problem by using a larger bearing rather than running a new piece through the CNC's.

Re: Alternate Source for 1/2" Flanged Hex Bearings

VEX has them in stock... just checked.

http://www.vexrobotics.com/bearings.html

Re: Alternate Source for 1/2" Flanged Hex Bearings

Quote:

Originally Posted by Chinske4296 (Post 1432026)

You may have better luck finding a bushing that has a 1/2" hex bore with a larger round O.D. Here, for example, is a 0.503" hex bore bushing with a 13/16" OD. You could potentially lathe that to a more common bearing size.