![]() |
Wiring the GTS from the 2008 KoP
We are planning on using the Gear Tooth Sensors from the 2008 KoP with this year's robot. The sensor uses both a Digital I/O connector to connect to DIO on the sidecar, but it also requires a 12V power supply. Where should this 12V supply be connected?
|
Re: Wiring the GTS from the 2008 KoP
It should be powered by a 20 Amp branch circuit from the Power Distribution Board.
|
Re: Wiring the GTS from the 2008 KoP
Okay, that's about the only place I could think of where we could legally get 12V, but it seemed like serious overkill. Thanks for the confirmation!
|
| All times are GMT -5. The time now is 08:02. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi