Chief Delphi - Weekly CAD, Mech, & Programming Challenges By DiscoBots 2587

Page 3 of 3

Show 100 post(s) from this thread on one page

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- General Forum (http://www.chiefdelphi.com/forums/forumdisplay.php?f=16)

- - Weekly CAD, Mech, & Programming Challenges By DiscoBots 2587 (http://www.chiefdelphi.com/forums/showthread.php?t=106842)

akoscielski3

28-06-2012 14:00

Re: Weekly CAD, Mech, & Programming Challenges By DiscoBots 2587

Quote:

Originally Posted by Madison (Post 1175693)

A bit of unsolicited advice:

Use hole wizard! It makes everything better and captures design intent more clearly.

I've used it in the past, but I don't like it. I may try it again but I've always found making the circles myself quicker.

Andrew Remmers

28-06-2012 14:42

Re: Weekly CAD, Mech, & Programming Challenges By DiscoBots 2587

Quote:

Originally Posted by akoscielski3 (Post 1175696)

I've used it in the past, but I don't like it. I may try it again but I've always found making the circles myself quicker.

I have found this much faster as well, however I have seen hole wizard's uses really well at work and have started using it some more because in drawings it automatically has all the hole properties.

- Andrew

n1ckd2012

29-06-2012 17:29

Re: Weekly CAD, Mech, & Programming Challenges By DiscoBots 2587

New challenges posted. Theme is "drivetrain". Link in OP.

All times are GMT -5. The time now is 15:10.

Page 3 of 3

Show 100 post(s) from this thread on one page