![]() |
Re: pic: How's this?
Quote:
Depending on your design, you might benefit from making the back plate of your shooter a little differently. Especially with a single shooting wheel, having some structure to help keep balls aligned is really helpful for repeatability. Here's a picture of Miss Daisy's shooter. They have a similar plate-and-standoff design to your own shooter, but they also have some inner plates to help guide balls down the center of their shooter. You can make this out of thin material since it's even less structural than the sides of your shooter and you should get a bit more of a repeatable shot. |
Re: pic: How's this?
For another reference, we did most of our shooter design out of 0.050" sheet metal. In a couple of spots (on the gearboxes) we had a few 1/8" plates, but for all of the hoods, mounting flanges, camera brackets, etc. we used 0.050" 5052.
-Brando |
| All times are GMT -5. The time now is 03:46. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi