2013 DAP 1522 Rev B1 Firmware
 

Hello all,
Just a note to say that when I went to use the 2013 FRC Bridge Configuration on the RevB1 Dap1522 bridges, I had issues. I first got a message saying that the firmware was illegal fresh out of the box (FW 2.02), but FW 2.03 works. Also, I found that in 2.4 GHz mode, it would not work, but does in 5 GHz mode.

Hope this helps.

Re: 2013 DAP 1522 Rev B1 Firmware
 

compboy07 posted the solution in this thread: http://www.chiefdelphi.com/forums/sh...rmware+illegal

Specifically, this post: http://www.chiefdelphi.com/forums/sh...80&postcount=3

With the solution that you found, the classmate does not support a 5GHz signal, like most other computers. So you may not be able to connect to your robot. I would recommend downgrading the firmware to 2.00 as shown in the post I linked.