Chief Delphi - FRC Bridge Programming Error

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Programming (http://www.chiefdelphi.com/forums/forumdisplay.php?f=51)

- - FRC Bridge Programming Error (http://www.chiefdelphi.com/forums/showthread.php?t=111009)

Joseph W. Horth

11-01-2013 17:57

FRC Bridge Programming Error

After following all the instructions listed on the FRC Bridge Configuration Utility I keep getting the same following error:

Quote:

Bridge Programming Failed: Failed to change IP Address
Please ensure the bridge is connected to this computer and try again

I have even tried changing my Local Connection Adapter IP Address to 10.2.80.255 with no luck with that either. What am I doing wrong?

dellagd

11-01-2013 17:58

Re: FRC Bridge Programming Error

Quote:

Originally Posted by Joseph W. Horth (Post 1213234)

After following all the instructions listed on the FRC Bridge Configuration Utility I keep getting the same following error:

I have even tried changing my Local Connection Adapter IP Address to 10.2.80.255 with no luck with that either. What am I doing wrong?

Which radio are you trying to configure (model number/name please)

Joseph W. Horth

11-01-2013 18:02

Re: FRC Bridge Programming Error

Quote:

Originally Posted by dellagd (Post 1213236)

Which radio are you trying to configure (model number/name please)

DAP1522 Rev B

Mark McLeod

11-01-2013 18:08

Re: FRC Bridge Programming Error

It's protesting that it cannot change the IP address of the computer you are running the Utility on.

Possibly you have other network connections Enabled?
Go to your Network adaptor settings and make sure all but the one Ethernet port you are using, are Disabled.

By the way, after the utility is done it may leave your computer's Ethernet IP set to 192.168.0.51 and you may need to change it back to DHCP or whatever you normally have it set to.

Joseph W. Horth

11-01-2013 18:32

Re: FRC Bridge Programming Error

Quote:

Originally Posted by Mark McLeod (Post 1213246)

I tried disabling the other network connections but to no avail. Is there any other information I could be leaving out that would help?

Mark McLeod

11-01-2013 18:36

Re: FRC Bridge Programming Error

You could try setting the Ethernet IP to 192.168.0.51 yourself. In case the utility checks before bothering to change it.

Joseph W. Horth

11-01-2013 18:42

Re: FRC Bridge Programming Error

Quote:

Originally Posted by Mark McLeod (Post 1213260)

You could try setting the Ethernet IP to 192.168.0.51 yourself. In case the utility checks before bothering to change it.

I just tried that and again it didn't work, should I try resetting my computer or reinstalling the Config Utility?

dellagd

11-01-2013 22:43

Re: FRC Bridge Programming Error

Reset the radio, put the radio in AP mode and see if you can access it on http://192.168.0.50 by connecting a laptop into one of its Ethernet ports

Barud

30-01-2013 14:07

Re: FRC Bridge Programming Error

Quote:

Originally Posted by Joseph W. Horth (Post 1213263)

I just tried that and again it didn't work, should I try resetting my computer or reinstalling the Config Utility?

-snip-

All times are GMT -5. The time now is 02:09.