Chief Delphi

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)
-   CD Forum Support (http://www.chiefdelphi.com/forums/forumdisplay.php?f=8)
-   -   New and can't figure out tank drive on LabView (http://www.chiefdelphi.com/forums/showthread.php?t=111026)

Vandy5710 11-01-2013 22:04

New and can't figure out tank drive on LabView
 
Hi I am on a rookie team and have no idea how to do tab drive on LabView, if you can help my team and I will very much so appreciate it
Thanks

ehochstein 11-01-2013 22:40

Re: New and can't figure out tank drive on LabView
 
Welcome to the forums, Vandy! I can help you find some resources on learning LabView. Have you installed the program yet? If so have you found the example/template programs?

On a side note I am volunteering at the regional (Northern Lights) you are attending as a robot inspector. You'll be able to find me there, I'll probably be wearing a bright yellow hat with a nametag that says "Evan" :)

Also the correct area to post labview questions is here.

Vandy5710 12-01-2013 00:06

Re: New and can't figure out tank drive on LabView
 
Thanks a ton, we have installed it and I found the templates and couldn't find anything but I didn't really know what I was looking for

ehochstein 12-01-2013 00:10

Re: New and can't figure out tank drive on LabView
 
I did not bring my laptop home tonight so I will be unable to give you any meaningful screenshots. I am going to private message you my email address. Please send me an email at some point tonight or tomorrow with any questions you may have. I'll reply tomorrow at some point with some good places to start.

Evan

Vandy5710 12-01-2013 00:16

Re: New and can't figure out tank drive on LabView
 
Ok sounds good thanks, it will be tomorrow because that's when we meet and I have access to the actual program


All times are GMT -5. The time now is 03:10.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi