Chief Delphi - Clarification on G23

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Rules/Strategy (http://www.chiefdelphi.com/forums/forumdisplay.php?f=6)

- - Clarification on G23 (http://www.chiefdelphi.com/forums/showthread.php?t=111273)

jmiller18

15-01-2013 00:21

Clarification on G23

Just for clarification, G23, reporduced below, the horizontal measurement is always in a plane parallel to the floor and not in a plane always parallel to the frame perimeter

Quote:

G23
A ROBOT’S horizontal dimensions may never exceed a 54 in. diameter vertical cylinder.

Violation: FOUL. If continuous or repeated violations, TECHNICAL FOUL.

dellagd

15-01-2013 00:22

Re: Clarification on G23

Quote:

Originally Posted by jmiller18 (Post 1215558)

Just for clarification, G23, reporduced below, the horizontal measurement is always in a plane parallel to the floor and not in a plane always parallel to the frame perimeter

Correct. It was asked in the Q and A and confirmed.

Slartibartfest

15-01-2013 20:40

Re: Clarification on G23

So if our robot is on the side of the pyramid it can extend to be, let's say, 55 in. long relative to the side of the pyramid?

Gregor

15-01-2013 20:43

Re: Clarification on G23

Check out this thread.

dellagd

15-01-2013 21:56

Re: Clarification on G23

The team update changed everything..... make sure you understand it.

All times are GMT -5. The time now is 06:28.