Chief Delphi - Bumper rules question

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Rules/Strategy (http://www.chiefdelphi.com/forums/forumdisplay.php?f=6)

- - Bumper rules question (http://www.chiefdelphi.com/forums/showthread.php?t=111371)

JZB	16-01-2013 12:16

Bumper rules question

We are building our bumpers and we dont understand the rule fully,
we painted figure A and B,
We are asking if both ways are right?
Is only one right?
Thx.

IndySam

16-01-2013 12:19

Re: Bumper rules question

A

R22

ROBOTS are required to use BUMPERS to protect all outside corners of the FRAME PERIMETER. For adequate protection, at least 8 in. of BUMPER must be placed on each side of each outside corner (see Figure 4-2).

The dimension defined in R22 is measured along the FRAME PERIMETER. The portion of the BUMPER that extends into the corner is not included in the 8 in. requirement.

ehochstein

16-01-2013 12:20

Re: Bumper rules question

protoserge

16-01-2013 13:53

Re: Bumper rules question

Quote:

Originally Posted by JZB (Post 1216544)

We are building our bumpers and we dont understand the rule fully,
we painted figure A and B,
We are asking if both ways are right?
Is only one right?
Thx.

A is correct as per the rules. B is not.

All times are GMT -5. The time now is 06:32.