mating 5V connector for D-link
 

I'd like to wire the +5V to the D-link radio without chopping the cable off of the power cube that shipped with the radio. Does anyone know the right dimensions for the mating connector?

Re: mating 5V connector for D-link
 

Re: mating 5V connector for D-link
 

Thank you

Re: mating 5V connector for D-link
 

According to the Robot Power Distribution Diagram found here, the d- link should be powered by the 12v to 5v convertor. The 5v on the PDB is for the camera.

Re: mating 5V connector for D-link
 

ericbanker is correct, the D-link should be powered by the 12V-5V converter that is supplied in the KOP. The converter should be wired into the small 12V connection near the cRIO power and 12V LED. The camera should go to the 5V port in the same area

Re: mating 5V connector for D-link
 

AndyMark is out of stock. Radio Shack carries the connector: http://tinyurl.com/c4ku48t

or MCM Electronics: http://tinyurl.com/cwoacnq

or a cable at Altex: http://tinyurl.com/cg8as8p

Not that hard to find

Re: mating 5V connector for D-link
 

I believe what he's asking is where to buy the plug that plugs into the radio because they don't want to cut the power brick apart.