| WileyB-J |
31-01-2013 22:01 |
Re: pic: 2386 chassis mock-up 2
Quote:
Originally Posted by Borobo
(Post 1224990)
Is that a 1/4 inch plate chassis? Why that over 1/8 or even smaller
|
Its 3/16; and it was supplied stock from a generous sponsor. We might be able to go 1/8th. We've gone thicker and it was unnecessary, but we feel any thinner will be an unnecessary compromise with not a noticeable weight difference. Besides, we can cut larger lightening holes out with 3/16 than we would with a thinner gauge to offset the difference in weight. Good question. |
