Chief Delphi - cRIO Imaging Error

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- General Forum (http://www.chiefdelphi.com/forums/forumdisplay.php?f=16)

- - cRIO Imaging Error (http://www.chiefdelphi.com/forums/showthread.php?t=113448)

anonymousguy31

13-02-2013 21:09

cRIO Imaging Error

I am currently trying to image my teams cRIO using the imaging tool but an error appears every time saying- "cannot assign IP adress- make sure that the reset ip switch is off". The switch is off, my computers ip is set correctly. I heard that you are supposed to do this using a crossover cable (I was using ethernet) so I tried to use a wireless bridge- same error. Any ideas?

bgg	13-02-2013 23:04

Re: cRIO Imaging Error

It's not recommended to image over wifi. I believe you should just use ethernet and not a crossover. Double check the documentation at the link below for correct IP settings. There is a virtual switch for IP reset for 4 slot or a physical switch for 8 slot cRio.

http://wpilib.screenstepslive.com/s/...ging-your-crio

All times are GMT -5. The time now is 10:54.