Chief Delphi - Drive Station Table

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Technical Discussion (http://www.chiefdelphi.com/forums/forumdisplay.php?f=22)

- - Drive Station Table (http://www.chiefdelphi.com/forums/showthread.php?t=113755)

Drive Station Table

We need to find out the height of the drive station shelf from the floor of the field. We have looked all over the plans of the field and have not been able to find the height. This year we made a new drive station but it is higher then we have had in any of our years in FRC. So we just want to make sure that the hight of the drive staion is logical to use because our driver is a bit on the shorter side, and we don't want him struggling to reach the controls.

So all in all what is the hight of the drive station shelf from the floor of the field?

Re: Drive Station Table

You want drawing FE-00004, the Drivers Station End Panel. It shows the distance from the floor to the bottom of the shelf to be 34 inches. The shelf itself is 1/8" 6061 aluminum.