hieght of the scoring ramp
 

Posted by Pat.

Student on team #101, STRIKER, from St. Patrick High School and LoDan Electrtonics.

Posted on 10/17/2000 9:59 AM MST



In the diagram of the scoring ramp, they do not asign a measurement to the height of the back. Does anybody know the angle of the ramp. If so, please respond.

Re: hieght of the scoring ramp
 

Posted by Nate Smith.

Other on team #66, GM Powertrain/Willow Run HS, from Eastern Michigan University and GM Powertrain.

Posted on 10/17/2000 12:47 PM MST


In Reply to: hieght of the scoring ramp posted by Pat on 10/17/2000 9:59 AM MST:



: In the diagram of the scoring ramp, they do not asign a measurement to the height of the back. Does anybody know the angle of the ramp. If so, please respond.

The height of the peak is approx. 6 inches, according to one of Joe's posts earlier today...linked to below. Also, the angled surface of the ramp is made of a 48x48 piece of plywood(again from Joe's post). This should give you the information you need to calculate the angle. Hope this helps...

Nate