Deploying code in labview
 

Hi I'm from a team here in houston. I was wondering what is the full proccess to deploy and launch the code in labview and FRC dashboard.

Re: Deploying code in labview
 

You have to go to the project window in LabVIEW, build all, and then deploy to real-time target

Re: Deploying code in labview
 

Tether your programming laptop to the cRIO.
Open your robot project in LabVIEW.

On the Project Explorer window...
All the way at the bottom of the list of folders you'll see
Build specifications
Expand it to see -> FRC Robot Boot-up Deployment

By right-clicking on FRC Robot Boot-up Deployment you'll get a pop-up menu.
- Choose "Build" and wait a few minutes for it to compile.
- Power up the robot (this is when you have to be connected to it)
- Then right-click on FRC Robot Boot-up Deployment again for the menu.
- Choose "Run as startup"
It'll take a few minutes to get your code onto the cRIO permanently.
-It'll ask if you want to reboot the robot, choose "Yes"

Start your driver station.
Make sure you have wireless or tethered connectivity to the robot.

Re: Deploying code in labview
 

You might find the documentation helpful.

http://wpilib.screenstepslive.com/s/3120

http://wpilib.screenstepslive.com/s/...abview-program