Pneumatics electrical wiring and programming
 

Posted by Dan Grostick at 1/18/2001 10:08 AM EST


Engineer on team #267, Demolition Squad, from North Broward Prep / St. Andrews.



I've posted information (in the White Papers section) on the electrical wiring and programming of the pneumatics subsystem. I want to share my experiences programming the pneumatics demo board shown at the First kickoff.

Dan Grostick (267)

Comment out the relay line in default program
 

Posted by Vince Wilczynski at 1/20/2001 8:15 PM EST


Engineer on team #124, Whalers, from New London / Montville/ Williams School and Notheast Utilities / US Coast Guard Academy.


In Reply to: Pneumatics electrical wiring and programming
Posted by Dan Grostick on 1/18/2001 10:08 AM EST:



Thanks Dan.
One note, make sure you comment out the relay5 lines in the default program as noted below:
'relay5_fwd = p1_sw_aux1 'Port 1 Aux1 = Relay 5 Forward
'relay5_rev = p1_sw_aux2 'Port 1 Aux2 = Relay 5 Forward
/