Chief Delphi - pic: RAMP Inspired Gearbox

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Extra Discussion (http://www.chiefdelphi.com/forums/forumdisplay.php?f=68)

- - pic: RAMP Inspired Gearbox (http://www.chiefdelphi.com/forums/showthread.php?t=123656)

Sh1ine

25-12-2013 17:43

pic: RAMP Inspired Gearbox

loading photo ...

Andrew Lawrence

25-12-2013 17:45

Re: pic: RAMP Inspired Gearbox

Looks great! This familiar design is a good way of running 3 CIM single speeds.

Just curious - why is the bearing on the bottom sticking out? Are you only running 3/16" thick plates?

Sh1ine

25-12-2013 20:53

Re: pic: RAMP Inspired Gearbox

No we use the bearing to locate the gearbox properly on the chassis.

Andrew Lawrence

25-12-2013 21:00

Re: pic: RAMP Inspired Gearbox

Quote:

Originally Posted by Sh1ine (Post 1316961)

No we use the bearing to locate the gearbox properly on the chassis.

Smart. I like that.

Cory	25-12-2013 21:06

Re: pic: RAMP Inspired Gearbox

It's hard to tell but your fillet sizes look a little small if you would be milling your plates. If you water jet, carry on.

All times are GMT -5. The time now is 23:24.