Chief Delphi

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)
-   Pneumatics (http://www.chiefdelphi.com/forums/forumdisplay.php?f=54)
-   -   Running Two Separate Solenoids off of one Spike (http://www.chiefdelphi.com/forums/showthread.php?t=125674)

ShaneKent253 02-02-2014 12:35

Running Two Separate Solenoids off of one Spike
 
Hello from Team 253,

We are wondering if we can run two solenoids off of one single spike. That is it, thank you.

Shane

EricH 02-02-2014 12:39

Re: Running Two Separate Solenoids off of one Spike
 
Explicitly allowed by R51.

jmartin 02-02-2014 12:41

Re: Running Two Separate Solenoids off of one Spike
 
Yes, you can, see the note after the table in rule R51:
Quote:

*Multiple low-load, pneumatic solenoid valves, electric solenoids or CUSTOM CIRCUITS may be connected to a single relay module. This would allow one (1) relay module to drive multiple pneumatic actions or multiple CUSTOM CIRCUITS. No other electrical load can be connected to a relay module used in this manner.

Ether 02-02-2014 12:41

Re: Running Two Separate Solenoids off of one Spike
 
Quote:

Originally Posted by ShaneKent253 (Post 1336298)
We are wondering if we can run two solenoids off of one single spike. That is it, thank you.

from the Game Manual:

Quote:

4.8.21 R51

Each power regulating device may control electrical loads per Table 4-4. Unless otherwise noted, each power
regulating device may control one and only one electrical load.

Table 4-4: Legal Power Regulating Device Use

Multiple low-load, pneumatic solenoid valves, electric solenoids or CUSTOM CIRCUITS may be connected to a single
relay module
. This would allow one (1) relay module to drive multiple pneumatic actions or multiple CUSTOM
CIRCUITS. No other electrical load can be connected to a relay module used in this manner.


All times are GMT -5. The time now is 05:38.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi