is 18 gage steel, used as a bracket on the chassis counted as an outward protrusion??
 

is 18 gage steel, used as a bracket on the chassis counted as an outward protrusion??

Re: Assistance
 

Please Help

Re: is 18 gage steel, used as a bracket on the chassis counted as an outward protrusi
 

Can you provide any more information? A picture, or drawing of what you're talking about will help.

Re: is 18 gage steel, used as a bracket on the chassis counted as an outward protrusi
 

We are making a bracket out of sheet metal in order to mount a piston over the wheels. The bracket will go from the inner brace on the chassis to the outer brace. Are we allowed to mount the sheet metal brace on the outside of the chassis? It will be protruding from the chassis about 1/16th of an inch. Thanks in advance!

Re: is 18 gage steel, used as a bracket on the chassis counted as an outward protrusi
 

A picture or diagram would be helpful, but 'chassis' is not a relevant term really. FRAME PERIMETER is relevant. It sounds like the 1/16 inch protrusion would re-define your frame perimeter because it is not a fastener like a bolt head, etc (which are not considered in determining your frame perimeter.

I'm envisioning a piece that has a right angle and is fastened to your chassis on its outer face. This just becomes your frame perimeter and the chassis element will be within 1/16" and so would be allowed because it is less than 1/4" depth.

Again, the above is based on some conjecture about what you are actually trying to do, so it may not reflect reality.

Re: is 18 gage steel, used as a bracket on the chassis counted as an outward protrusi
 

As long as you stay inside the max frame perimeter 112 in you will be fine.

Re: is 18 gage steel, used as a bracket on the chassis counted as an outward protrusi
 

It's hard to visualize what you mean. I surmise that your steel piece would end up defining your frame perimeter, rather than being considered a "minor protrusion".

Re: is 18 gage steel, used as a bracket on the chassis counted as an outward protrusi
 

I've found a rule pertaining to a protrusion of that diminutive size. look at 4.1 R2 and if that doesn't feel acceptable you should ask the Q&A

Re: is 18 gage steel, used as a bracket on the chassis counted as an outward protrusi
 

R2 is what you have to comply with. As long as a small bracket & bolt did not exceed 1/4", I would consider it a minor protrusion. At some length a bracket would cease to be minor. Inside the bumper zone it could be considered part of the frame perimeter. Legal if the rule frame perimeter rules are met. Outside the bumper zone it would have to be a minor protrusion. Q&A generally punts these kinds of questions so ultimately it will be up to your robot inspector.

Re: is 18 gage steel, used as a bracket on the chassis counted as an outward protrusi
 

Be very careful saying that. It all depends on where the bumpers end up relative to this bracket, because if this bracket redefines the frame perimeter then it also changes their bumpers!

Re: is 18 gage steel, used as a bracket on the chassis counted as an outward protrusi
 

True, but its up to them to determine that. I was answering the question asked, and without more info or a picture I'm not going to bring in more rules to cloud the waters.