Chief Delphi

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)
-   Pneumatics (http://www.chiefdelphi.com/forums/forumdisplay.php?f=54)
-   -   Solenoid breakout wiring help (http://www.chiefdelphi.com/forums/showthread.php?t=126251)

Ikillee 11-02-2014 14:50

Solenoid breakout wiring help
 
The cable for FESTO VUVG valve attaches to the solenoid (24V) through the black clip. How does the other side (open wires) attach to the solenoid breakout? Do you soder them on the pins or something?

Joe Ross 11-02-2014 15:17

Re: Solenoid breakout wiring help
 
We connect them (typically solder) to the 2 pin cables in the kit, and then plug the 2 pin cables into the breakout.

Lightfoot26 11-02-2014 15:27

Re: Solenoid breakout wiring help
 
Quote:

Originally Posted by Joe Ross (Post 1341298)
We connect them (typically solder) to the 2 pin cables in the kit, and then plug the 2 pin cables into the breakout.

This is typically how we do it as well. I have also wired it through flat Cat5 cable before, particularly when we have a large array of solenoids, but then terminate the cables with the festo clips on one end and a pwm connector on the other (only using 2 pins). Also, you mentioned 24v, so remember, you need to supply 24v power to your module from the PDB! I've see 24v solenoids running to a 12v supplied module one to many times!!!


All times are GMT -5. The time now is 05:22.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi