Chief Delphi

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)
-   Pneumatics (http://www.chiefdelphi.com/forums/forumdisplay.php?f=54)
-   -   Solenoid Breakout Always Sending Power (http://www.chiefdelphi.com/forums/showthread.php?t=126286)

slhs 11-02-2014 22:37

Solenoid Breakout Always Sending Power
 
So we connected out solenoid breakout and it is always sending power to all outputs. We tested it with a volt meter and it is even sending power when the robot is disabled. We are using 24v for the breakout.


Any help would be really appreciated! Thanks in advance!

Joe Ross 11-02-2014 22:46

Re: Solenoid Breakout Always Sending Power
 
Are the green LEDs lit on the NI 9472 module? Is the 9472 module in slot 3 of the cRIO?

slhs 11-02-2014 22:51

Re: Solenoid Breakout Always Sending Power
 
Well it is sending power regardless if the lights are on on the module. We tested it both ways. Yes it is in the 3rd slot.

Gregor 11-02-2014 23:11

Re: Solenoid Breakout Always Sending Power
 
It shouldn't make a difference for your issue but have you wired the solenoid breakout to 24v and not 12v?

Pictures of your CRIO and PDB would help.

slhs 11-02-2014 23:12

Re: Solenoid Breakout Always Sending Power
 
It is wired to the 24v connector, the same one as the one for the cRIO.

RufflesRidge 12-02-2014 08:24

Re: Solenoid Breakout Always Sending Power
 
Have you verified that the power input to the Solenoid Breakout is hooked up properly (i.e. not backwards)?

slhs 12-02-2014 09:04

Re: Solenoid Breakout Always Sending Power
 
Yes we have checked that. We connected it red-black-red-black in the same place as the cRIO power. And on the other side it follows the positive and negative on the Breakout bumper.


All times are GMT -5. The time now is 05:47.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi