Re: December Design Competition 2014: Tubular Touchdown
 

They swivel.

Re: December Design Competition 2014: Tubular Touchdown
 

1. Does blocking a robots movement by use of the mobile goal qualify as a pin?

2. The mobile goals may not be grasped during Fourth down are we to assume that means a robot cannot grasp it but an alliance can by using multiple robots move it more effectively?

3. Is the horizontal extension limited to 20" in one direction or are we allowed to have multiple extrusions at once?

4. Are you allowed to load game balls into your robot pre-match and hold onto them until Fourth Down

5. Which determines the the position of the mobile goal at the end, its final resting position or its position at when the time runs out?

Re: December Design Competition 2014: Tubular Touchdown
 

Since we've now reached the halfway point into the competition, I would like to leave this small teaser of things to come:

Re: December Design Competition 2014: Tubular Touchdown
 

1. Yes

2. The mobile goals may not be grasped during the Fourth down. It means what it means.

3.Similar to past rules, you can have multiple extensions

4. No you are not.'

5. While we do not expect the goals to be moving with a great enough velocity at the end of the match for it to matter, I will say 5 seconds after the match ends the match will be scored.

Re: December Design Competition 2014: Tubular Touchdown
 

Loving the design so far! Can't wait to see the whole thing!

Re: December Design Competition 2014: Tubular Touchdown
 

Neat!

I would like to point teams toward some cool gate latch style mechanisms in 2010 that allowed robots to grab onto a vertical pole by driving into it, without actuating anything. The mechanisms used in 2010 didn't release, but I'm sure you can figure out a way to accomplish that.

Here's a picture of a pole grabbing mechanism 1114 used in 2010. The rules of this competition require the ability for such a mechanism to release. How could that be accomplished?

Re: December Design Competition 2014: Tubular Touchdown
 

Is the ' 2" high 1" wide ' speed bump a typo? Based on the picture it looks like a semicircle.

Re: December Design Competition 2014: Tubular Touchdown
 

You may be misreading - the document shows 2" high (2 inches high) and 1' wide (1 foot wide)

Re: December Design Competition 2014: Tubular Touchdown
 

5 more days until submission time! We're Looking Forward to seeing what all y'all have done to complete this challenge!

Re: December Design Competition 2014: Tubular Touchdown
 

When/How can the community expect to see submissions and the winners?

Re: December Design Competition 2014: Tubular Touchdown
 

We are hoping to complete judging and contact the winners in the next day or so. From there if the winners are cool with us making it public we will announce it on this thread.

Re: December Design Competition 2014: Tubular Touchdown
 

Did you ever make any of the designs public? I'd love to see some of them.

Re: December Design Competition 2014: Tubular Touchdown
 

It appears that Andrew Lawrence's Chief Delphi account no longer exists. At this point, I seriously doubt that we will ever know who won.

Re: December Design Competition 2014: Tubular Touchdown
 

As far as I'm aware, we didn't receive any submissions. Probably due to time of year and commitments, since December probably isn't the best time for it.

Re: December Design Competition 2014: Tubular Touchdown
 

What did happen to Andrew's account? AFAIK, he's still involved with FIRST, and I did quite like his posts.

As for the design competition, I'm sad that nobody submitted. It was really well done, so our team may reuse these rules for design lessons/fake kickoff if we get around to meeting in the summer.