Originally Posted by maddoctor90 (Post 1415203)

What wire gauge and twist count is used for the CAN wires on the Talon SRX?

Originally Posted by maddoctor90 (Post 1415203)

What wire gauge and twist count is used for the CAN wires on the Talon SRX?

Originally Posted by Richard Wallace (Post 1415246)

Used, or recommended by the developer?

While beta testing, our team used 20 AWG green and yellow purchased on separate spools (e.g., McMaster 8054T14) and twisted pairs ourselves with a vise and drill, to about 20 twists per foot. So far no issues. We twisted to get good handling/routing, not to solve an EMI problem.

Originally Posted by Aren_Hill (Post 1415269)

The wire spec is 20AWG per the drawing on the site, the twist spec we use is 1 revolution per 14-21mm.

-Aren

Originally Posted by Jared (Post 1415172)

The output shafts and shifting dogs for the WCP DS gearbox seem to be dead links right now. Do you still plan to sell the output shafts and shifting dogs separately?

Also, can the shorter steel shaft that fits inside the gearbox output shaft be purchased separately too?

Originally Posted by Aren_Hill (Post 1415284)

The Shifter rod has been added to the 217-3628 Shifter dog Kit.
http://www.vexrobotics.com/217-3628.html

And yes the shifter output shaft will still be available by itself.
http://www.vexrobotics.com/217-3635.html

-Aren

Originally Posted by Aren_Hill (Post 1415284)

The Shifter rod has been added to the 217-3628 Shifter dog Kit.
http://www.vexrobotics.com/217-3628.html

And yes the shifter output shaft will still be available by itself.
http://www.vexrobotics.com/217-3635.html

-Aren

Originally Posted by Mr V (Post 1414848)

I have found that Nylock nuts and bolts do not vibrate loose in FRC applications and if there is a situation where a Nylock is not suitable then we use medium strength thread locker. Once I introduced thread locker to the team there have not been any instances were a fastener came loose.

Where to you find rivet nuts that go in a 1/4" hole all the ones I've ever found use the annoying 19/64" bit. Because it is a less than common size we keep it in the kit with the rivet nuts so it is there when we need it.

Originally Posted by RoboChair (Post 1416246)

Our 2007 Aim high robot vibrated 1/4-20 nylon lock nuts off... multiple times...

Originally Posted by ToddF (Post 1419255)

Now, if you would just get 2 CIM ball shifters in stock...