RoboRIO connectivity Issues
 

When I deploy code locally (No Build/Burn) using LabVIEW with the roboRIO, I am experiencing periodic and short-lived disconnect messages through LabVIEW. When enabled and driving, the code never experiences an interruption, but I cannot probe the values of subVIs nor do their indicators update when opened in say AutonomousIndependent.vi. I thought at first it may be a packet loss issue, but the same problem arises when connected over USB and wireless, and with two different computers. Additionally, neither the driver station nor the roboRIO were under any sort of processing stress, maybe 20% tops during these issues. Any ideas on why this is happening?

Attached is an image from an older version of LabVIEW (I didn't screen shot the error) but it in essence has the same message that I am getting now.
Thanks,
FRC Team 1676

Re: RoboRIO connectivity Issues
 

Not a long term fix but for testing you can run your code remotely by disabling startup rt and fpga in Web dash. Just be sure not to forget that you did.