Chief Delphi

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)
-   Pneumatics (http://www.chiefdelphi.com/forums/forumdisplay.php?f=54)
-   -   Issues with SMC SS5Y3-41-06-N7T 6 Station Base Mount (http://www.chiefdelphi.com/forums/showthread.php?t=134086)

ChrisTeam1289 06-02-2015 17:21

Issues with SMC SS5Y3-41-06-N7T 6 Station Base Mount
 
Hey,

We are currently having issues with the SMC SS5Y3-41-06-N7T 6 Station Base Mount, we have the entire pneumatics system working, up until we connect tubing into the pressure port, and then we can't get any pressure readings, however if we remove the tubing from the port and cover the open end with our thumb we will get pressure readings, we are really stumped at the moment and could use some help.

Cecil 06-02-2015 17:27

Re: Issues with SMC SS5Y3-41-06-N7T 6 Station Base Mount
 
What do you mean by pressure readings?

Did you remove the plug on the other side of the base station, put teflon tape on it and tighten it back in?

Do you have any unused spaces for solenoids? Do you have blank station kits installed over any port without a solenoid?

Do you have cylinders attached to both the input and output of all of your solenoids?

Did you install the gaskets below each solenoid and make sure they are tight on the base kit?

Nate Laverdure 06-02-2015 18:50

Re: Issues with SMC SS5Y3-41-06-N7T 6 Station Base Mount
 
Quote:

Originally Posted by ChrisTeam1289 (Post 1439445)
...if we remove the tubing from the port and cover the open end with our thumb...

FYI:
Quote:

A pressure of 7 bar [100 psi] is sufficient to penetrate the skin.
Please don't use your body as a troubleshooting tool.


All times are GMT -5. The time now is 05:37.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi