pic: 4183 Wooden Swrrrv
 

Re: pic: 4183 Wooden Swrrrv
 

I want a video of this driving, please. If that module holds up, that would be really awesome.

EDIT: Is that wooden disc on a bearing, or are you using a wood bearing?

Re: pic: 4183 Wooden Swrrrv
 

I hope the gears aren't wood too.

Re: pic: 4183 Wooden Swrrrv
 

Gears aren't wood, but the chain is :D

They only have one module, and no code yet that I know of. Just a fun side project to make with the laser cutter.

Re: pic: 4183 Wooden Swrrrv
 

What are you using to support the robot weight?

Re: pic: 4183 Wooden Swrrrv
 

The wood disk is a bearing, laser cut edge on laser cut edge with some grease.

Just the steering gears.

There will be a thrust bearing between the top of the module and the top sheet on the housing.

Re: pic: 4183 Wooden Swrrrv
 

Can you post pictures showing off the internals too?

This is way cool!

Re: pic: 4183 Wooden Swrrrv
 

Here are some pictures of the guts.






We copied the basic geometry from the latest 221 revolution pro and added the lower support similar to wild swerve.

Didn't have any 3/8" hex bearings so we made a 1/2" hex to 3/8" hex shaft.

If other portions of the robot hadn't taken up so much time, I'm sure we would have used it. Unfortunately, there's a lot of negativity on these forums regarding designing a swerve drive in a build season :rolleyes: So expectations were slim and we went with omniwheels. This was made in the first 2 weeks with very little effort, maybe 10 hours, while we focused on other prototypes.