Getting value from Potentiometer on SRX Talon
 

Hi,
We're using a command based robot written in Java and trying to use a 10 turn precision potentiometer (am-2619) hooked into an SRX Talon for our lift system but we cannot figure out how to get the value of its rotation back from the Talon.

Re: Getting value from Potentiometer on SRX Talon
 

talon srx software reference manual
http://www.crosstheroadelectronics.c...ol_system.html

Re: Getting value from Potentiometer on SRX Talon
 

We've tried using AnalogInPosition, getPosition, and AnalogInVelocity and the only one we get changes from is AnalogInVelocity.

Re: Getting value from Potentiometer on SRX Talon
 

Post a (focused) picture showing the connections at both the Talon end and the MA3 end.

Re: Getting value from Potentiometer on SRX Talon
 

Go the talon page on web dashboard and make sure the input is reading correctly. Hardware wise it is easy to exchange the wiper with one of the ends of the pot. Makes for funky readings that sort of work

Re: Getting value from Potentiometer on SRX Talon
 

I won't be able to get any pictures till Monday but thank you for your help so far.

Re: Getting value from Potentiometer on SRX Talon
 

Here's the pictures. I wasn't sure what the MA3 was so I just took a picture of all the connections I could.

Re: Getting value from Potentiometer on SRX Talon
 

So what value did you get from getAnalogInPosition().

If it's near 0, then the analog input pin is being pulled to ground externally.
If it's near 1023, it's being pulled to positive voltage (greater then 5V at the analogbreakout input, or greater than 3.3V at the Talon input).
If it's near 100 then it's floating (not connected to anything).

Also it might just be easier to grab the self-test results in the web-based config (section 2.4). That will rule out bad code.

Use a DC meter to confirm you are getting 0 - 5V swing on the analog input pad on the breakout. Your MA3 might not be getting power. Rotate the mechanism slowly while monitoring the voltage of the analog signal.

Re: Getting value from Potentiometer on SRX Talon
 

It was 102 so I'll talk to electrical about it tomorrow. Thank you for your help.

Re: Getting value from Potentiometer on SRX Talon
 

Yep sounds like it's floating (section 16.21 in Talon SRX Software reference manual).