2015 FIRST Design Book - 3D printing and CNC mill/lathe submissions needed
 

Initial submissions of team case studies for possible profiling in the 2015 FIRST Design Book have been strong and supplied great content for the book.

We still have a need for submissions in the use of 3D printing and CNC mills/lathes for teams that applied these technologies on their 2015 FRC robot.

If you have material for these chapters of the book, drop us a note at FRCBook2015@usfirst.org and we can walk you through the submission process.

We are now in the midst of the review and writing process, so the time is right to chat about your team's participation in the project in these two areas.

Re: 2015 FIRST Design Book - 3D printing and CNC mill/lathe submissions needed
 

Is the email address listed correct? I got a kick back on the one listed above. I'm assuming its intended to be FRCBook2015@usfirst.org. Is this right?

Brando

Re: 2015 FIRST Design Book - 3D printing and CNC mill/lathe submissions needed
 

Oops.... now corrected - thanks!